Clutch Plate，194-1111-000、1030-1112-000、1908-1113-000，67321-01100，68421-00100，68421-00101，69421-00100，69421-002008，1941111000，10301112000，19081113000，for Mitsubishi

The installation steps and precautions for Mitsubishi clutch friction plates are as follows: Installation Steps •  Preparation Work: Park the vehicle on a flat ground, pull up the handbrake, and prepare the corresponding tools such as wrenches.  •  Removal of Related Components: Remove the bolts of the clutch release, clutch friction plate, and clutch pressure plate in sequence, and take down these components.  •  Cleaning the Installation Surface: Clean the surfaces of the flywheel and pressure plate, remove oil stains, impurities, and dust, and ensure the installation surface is flat and clean.Installing the new friction plate: The side of the clutch driven plate with the damping disc should be installed facing the pressure plate, that is, the side of the driven plate with the protruding damping spring should face the pressure plate. The direction can also be determined according to the marks on the clutch plate. Some clutch plates will be marked with "Front" or "Back" on the edge or surface.  •  Installing the pressure plate: Install the pressure plate back to its original position, use a guide locator or the transmission input shaft for centering to ensure the driven plate is concentric with the pressure plate. Then tighten the pressure plate bolts one by one diagonally according to the specified torque, and the tightening torque is generally 25Nm.  •  Installing the clutch release: Install the clutch release back to its original position and tighten the bolts.Adjust relevant components: Adjust the installation position of the clutch release fork shaft transmission arm so that the distance from the fixed cable nut bracket is between 195mm and 205mm. At the same time, adjust the free travel of the clutch pedal to 15mm-25mm.

NotesAlign Marks: The alignment marks on the clutch cover, pressure plate, and diaphragm spring should be aligned.Apply Grease: During assembly, each pivot point, bearing surface, and release bearing should be coated with base grease.Check Fit: Before installation, check the fit between the splines of the clutch driven plate hub and the input shaft splines to ensure free movement without jamming and no obvious looseness.Use Special Tools: It is recommended to use a clutch installation tool to prevent deformation or damage to the clutch plate due to improper operation.

References：The content you provided regarding the installation of Mitsubishi clutch friction plates is partially sourced from relevant articles on Autohome. Among them, contents such as "The side of the clutch driven plate with the damping disc should be installed facing the pressure plate", "When installing the clutch pressure plate assembly, a guide locator or the transmission input shaft is required for centering to ensure the driven plate is concentric with the pressure plate", "The pressure plate must be in contact with the flywheel. Tighten the bolts. When tightening, tighten them one by one diagonally with a tightening torque of 25Nm", "The installation position of the clutch release fork shaft transmission arm must be 195mm-205mm away from the fixed cable nut bracket", and "Adjust the free travel of the clutch pedal to 15mm-25mm" are from the Autohome article "Replacing the Clutch Plate of Mitsubishi Pajero". Moreover, precautions like "The alignment marks on the clutch cover, pressure plate and diaphragm spring should be aligned" and "During assembly, each fulcrum, supporting surface and release bearing should be coated with basic grease" are mentioned in both the Autohome articles "Replacing the Clutch Plate of Mitsubishi Pajero" and "What Are the Precautions for Installing Clutch Friction Plates?".