Clutch Kit 1601200FA for JAC1035 JAC1040 JAC1040S

Overview of the 1601200FA Clutch Kit

The 1601200FA clutch kit bundles the three parts that wear together: pressure plate, friction disc and release bearing. Fitting them as a set is the only way to be sure the clamp load, the friction coefficient and the release geometry all match.

The part is supplied ready to fit, with the dimensions and the interface points matched to the original. That matters on a service part: a pulley, regulator or clutch component that is close but not correct will fail early and take surrounding parts with it.

Specification Summary

• Pressure plate with matched clamp load
• Friction disc with the original spline count
• Release bearing included
• Alignment tool supplied where required

Reference Numbers and Cross References

The part is listed under the following references:

• 1601200FA
• 1601100FA
• 60RCT3525F0
• JAC1035
• JAC1040
• JAC1040S

Application Notes

On JAC1035 JAC1040 JAC1040S installations the gearbox is removed. Inspect the flywheel face, the release fork and the spigot bearing while the kit is going in.

Confirm the number against the vehicle before ordering. Where a model was built with more than one driveline or charging variant, the part number is the only reliable guide.

Failure Modes

Clutches wear as a set: the disc lining thins, the pressure plate loses clamp load and the bearing loses grease. Replacing only the disc leaves a weak cover and a noisy bearing behind.

Oil contamination and misalignment finish a clutch early. A leaking rear main seal ruins the new lining, and a worn fork makes the new bearing work at an angle.

Fault Symptoms

• Clutch slip under load
• Judder when pulling away
• Noise when the pedal is pressed
• High or low bite point
• Burning smell after hill starts

Checking Before Replacement

Check the flywheel for cracks, hot spots and wear steps. Machine or replace it as required before fitting the kit.

Inspect the mating surfaces and the fasteners before assembly. Most early failures trace back to something that was not renewed alongside.

Installation Notes

Clean the flywheel, align the disc with the tool supplied, fit the cover and torque the bolts in a cross pattern. Fit the new bearing, check pedal free play, then bed the clutch in gently for the first few hundred kilometres.

Related Parts to Check at the Same Time

• Flywheel
• Release fork and guide sleeve
• Spigot bearing
• Clutch cable or release cylinder

Quality Control and Supply

Dimension, material and function checks are carried out per batch before packing. Hejian Nuojin Auto Parts Co., Ltd. supplies the part in neutral packaging with a one-year warranty.

Frequently Asked Questions

Is a warranty included?

Yes, one year against manufacturing defects, with neutral packing for resale.

How do I confirm the part number?

Read the number from the old unit, not from a catalogue illustration. Compare the key dimensions at the same time.

Can I fit this without special tools?

Most of these parts fit with standard hand tools. A pulley needs a spline holding tool, and a clutch needs an alignment tool.

What else should be replaced at the same time?

Anything that touches the new part: belts and tensioners for a pulley, brushes for a regulator, the disc, bearing and flywheel face for clutch work.