0001108445 0001107452 0001107453 06E911021B 079911021D Starter Motor for Audi

The installation of Audi car starters must be strictly carried out according to the vehicle model and engine configuration. There are significant differences in location, tools, and steps for different model years and engine displacements. The following is a general process and key points explanation: Steps Operation Content Tools / Precautions 1. Preparation Confirm the fault and purchase a matching original or certified starter; check the appearance and model Diagnostic tool, wrench, socket, torque wrench, jack, etc. 2. Power off Disconnect the negative terminal of the battery, pull the handbrake and park the vehicle properly To prevent electric shock and accidental start 3. Locate Mostly between the engine and transmission, trace along the positive battery cable Some require removing护板 (protective panel), air deflector, or half shaft heat shield 4. Remove old parts Disconnect wire connections (B+ main cable and 50 control line), make marks; remove fixing bolts (commonly 2, about 65 N・m) Pay attention to bolt position and sequence to avoid dropping 5. Clean Clean the installation surface, carbon brushes, gears, etc., lubricate if necessary High-temperature lubricant, to prevent jamming 6. Install new parts Align the holes, tighten in diagonal order to the specified torque Check for no interference 7. Wiring Connect B+ and 50 lines, ensure good contact Avoid reverse connection or looseness 8. Restore Reinstall护板 (protective panel), heat shield, air deflector, etc. Restore to original position 9. Test Reconnect the battery negative terminal, start the vehicle, check operation and abnormal noise Conduct road test only if no abnormalities occur